Review runs settings to set the scale used for the simulation report
- Move to a cutting pattern
- Select the tab at the foot of the report: Saw simulation
- Select: Settings - Report settings - Additional
The saw simulation report shows a diagram of the cutting operations for a cutting cycle. The bottom axis of this diagram shows the elapsed time. The scale of this axis can be varied to alter the overall size of the diagram.
- Enter the number of minutes that the display or page width represents
(For example, 2 minutes)
A higher number means that the report is more likely to fit on to a single page but shows less detail. If the value is zero the program uses a default (typical) value.
See: Report / Export settings - Options (other)
